Almost everything we know about stars — their temperature, composition, speed, even whether they have planets — we learn from their light alone. To collect that light we need a telescope, and to “read” it we need spectroscopy. In this lesson we study the physics of both, with formulas.
What does a telescope do?
A telescope has three key properties: light-gathering power, resolving power and magnification. Telescopes with a lens objective are refractors; those with a mirror are reflectors. Newton built the first working reflecting telescope in 1668. Today all large telescopes are reflectors: a huge mirror can be supported from behind, and unlike a lens it produces no coloured fringes (chromatic aberration).
Where
- P
- amount of light collected (light-gathering power)
- D
- diameter of the objective (mirror), m
Collected light is proportional to the area of the objective, i.e. to D².
Example 1: the eye, an amateur telescope and Shamakhi’s 2-metre telescope
Problem
The pupil of a dark-adapted eye is about 7 mm across. a) How many times more light does a 20 cm telescope collect than the eye? b) The 2-metre telescope of the Shamakhi observatory? c) If the naked eye reaches magnitude 6, what limiting magnitude does the 20 cm telescope reach?
Show solutionHide solution
Solution
b) (2000 mm / 7 mm)² ≈ 286² ≈ 82,000 times.
c) Convert the brightness ratio to magnitudes: Δm = 2.5 · log₁₀ 820 ≈ 2.5 · 2.91 ≈ 7.3.
Limiting magnitude ≈ 6 + 7.3 ≈ 13.3.
Because light is a wave, even a perfect telescope shows a point-like star not as a point but as a tiny diffraction disc. The smallest angle at which two stars can still be seen as separate is the resolution limit (Rayleigh criterion). It is proportional to the wavelength and inversely proportional to the diameter.
Where
- θ
- resolution limit, radians (1 rad = 206,265″)
- λ
- wavelength, m
- D
- diameter of the objective, m
Example 2: Hubble and a radio telescope
Problem
a) Find the resolution limit of the Hubble telescope (D = 2.4 m) at λ = 550 nm. b) Find the resolution of a 100 m radio telescope at the neutral hydrogen wavelength λ = 21 cm and compare it with the human eye (≈ 60″).
Show solutionHide solution
Solution
θ ≈ 2.8 · 10⁻⁷ · 206,265 ≈ 0.06″ (for ground telescopes the atmosphere usually limits sharpness to about 1″).
b) θ = 1.22 · 0.21 / 100 ≈ 2.6 · 10⁻³ rad ≈ 530″ ≈ 9′ — about 9 times worse than the eye! That is why radio astronomers link widely separated antennas (interferometry): then the baseline B between antennas replaces D, θ ≈ λ / B.
Where
- M
- magnification (angular)
- F
- focal length of the objective, mm
- f
- focal length of the eyepiece, mm
For example, F = 1000 mm, f = 25 mm → M = 40×.
The atmosphere lets through mainly visible light and radio waves (the atmospheric windows); it absorbs X-rays and ultraviolet and much of the infrared. That is why X-ray and infrared astronomy is done mostly from space, while ground telescopes correct atmospheric turbulence with adaptive optics.
Spectroscopy: reading the light
- Continuous spectrum — a hot dense body (solid, liquid or dense gas) emits at all wavelengths.
- Emission lines — a hot, thin gas gives bright lines only at certain wavelengths.
- Absorption lines — a cooler gas in front of a hot source produces dark lines at those same wavelengths.
These are Kirchhoff’s laws. The lines of each chemical element are its “fingerprint”. Fraunhofer studied the dark lines in the solar spectrum in detail; in 1868 an unfamiliar yellow line was found in the Sun’s spectrum, and a new element — helium — was “discovered” on the Sun before it was found on Earth. Lines arise when electrons jump between energy levels in atoms.
Where
- E
- photon energy, J (1 eV = 1.602 · 10⁻¹⁹ J)
- h
- Planck constant, 6.626 · 10⁻³⁴ J·s
- f
- frequency, Hz
- c
- speed of light, 3.00 · 10⁸ m/s
Where
- R
- Rydberg constant, ≈ 1.097 · 10⁷ m⁻¹
- n₁, n₂
- lower and upper levels of the hydrogen atom (n₂ > n₁); n₁ = 2 is the visible Balmer series
Example 3: the red Hα line of hydrogen
Problem
An electron in a hydrogen atom drops from level n₂ = 3 to level n₁ = 2. Find the wavelength and energy of the emitted photon.
Show solutionHide solution
Solution
λ ≈ 6.563 · 10⁻⁷ m = 656.3 nm (red).
E = h·c / λ = 6.626 · 10⁻³⁴ · 3.00 · 10⁸ / 6.563 · 10⁻⁷ ≈ 3.03 · 10⁻¹⁹ J ≈ 1.89 eV.
This is in the visible red part of the spectrum — the Hα line is what gives glowing nebulae their pinkish-red colour.
The Doppler effect: how fast stars move
If a source moves away from us, its spectral lines shift towards longer wavelengths — to the red; if it approaches, they shift to the blue. From the size of the shift we get the radial velocity (the speed along the line of sight). This is how we measure the rotation of stars, the orbits of binary stars and the recession of galaxies. A planet makes its star “wobble”: Jupiter, for example, moves the Sun at about 13 m/s — many exoplanets were found this way.
Where
- Δλ
- shift: λ(observed) − λ₀, nm
- λ₀
- laboratory (rest) wavelength, nm
- vᵣ
- radial velocity, km/s; vᵣ > 0 means receding
Example 4: a star’s radial velocity
Problem
In a star’s spectrum the Hα line appears at 656.5 nm instead of 656.3 nm. Is the star approaching or receding, and how fast?
Show solutionHide solution
Solution
vᵣ = c · Δλ / λ₀ = 300,000 km/s · 0.2 / 656.3 ≈ 91 km/s.
Where is it used?
- Chemistry and ecology — spectrometers identify substances and measure air pollution.
- Medicine — X-ray, infrared and optical imaging; the light-sensitive chips (CCDs) used in telescopes also work in digital cameras and medical devices.
- Engineering — radar and lidar measure speed using the Doppler effect (for example, traffic police radars).
Remember
- Light-gathering power grows as D²; the resolution limit is θ ≈ 1.22·λ/D.
- Magnification M = F/f, but the diameter sets the detail; useful magnification ≈ 2 × D(mm).
- Kirchhoff’s laws: continuous, emission and absorption spectra; each element has its own lines.
- Hydrogen lines: 1/λ = R(1/n₁² − 1/n₂²); Hα = 656.3 nm.
- Doppler: Δλ/λ₀ = vᵣ/c; redshift means receding, blueshift means approaching.